|
What is a Secondary Tap Pedestal?
A secondary tap pedestal houses connectors for secondary wires fed by the secondary side of a transformer. Nordic’s connectors have a conductor range of 750MCM down to 1/O wire. The ND-3624 pedestal can accommodate up to 3 or 4 connectors with either 8, 10, or 12 ports with it’s fiberglass mounting brackets.
What’s the benefit of a secondary tap pedestal?
This system is the preferred method of terminating 600V conductors in residential and small commercial applications like apartment complexes and strip malls. Customers will be able to save money on installing fewer transformers, elbows, primary cable, and labor. The ND-3624 secondary tap pedestal is made of fiberglass and will not rust. It can either be pad-mounted to a concrete pad with a cabinet anchor system or direct buried down to 12” below grade.
 What are the connectors?
- Connectors are manufactured from high strength 6061-T6 aluminum alloy to provide premium electrical and mechanical performance.
- Suitable for use with either copper or aluminum conductors.
- Clear plated.
- Wire range from 750MCM down to 1/O.
- For large service runs and non-bus bar splices.
- Connectors are evenly distributed between each other to give you room to work safely.
 Product description:
ND-362436-MG-4HDB-10750-X
ND: = Nordic Design
362436: 36 = 36” Wide at the top, 24 = 24” Operating Depth, 36 = 36” Tall
MG: = Munsell Green, availabe in WG = Willow Green
4HDB: = 4 heavy duty brackets, 3HDB = 3 heavy duty brackets
10750: 
X = no connector installed
If there is no letter in front of the numbers, it’s the standard connector
Prefixes:
L = Lay-In, Z type connector
I = In-Line connector
LI = Lay-In, In-Line Connector
10750: 10 = 10 Port, 750 = 750MCM connector
Also available: 8750; 8 port, 750MCM, 12750; 12 port, 750MCM
X: = No ground system installed
B1A = 3/8” copper ground rod
W1A = #2 copper strand wire with ground lugs.
See catalog page
|
